Retro '58-'60 Corvette Body
Our new and improved version of the original Corvette, exact in every way except made of fewer parts to reduce assembly time thereby allowing us to maintain reasonable pricing. We have eliminated the spare tire wheel well to make room for the new high temperature exhaust systems.
Also larger tires will not fit in the old 5 1/2" deep well. This is not a racing shell. Some parts are over sized to allow your body finisher to give you that fit you deserve and want.
We spent many - many hours smoothing and re-aligning an original '58 Corvette before tooling all new molds.
Trunk Lid - Top Cover - Hood comes assembled with mounting plates in place. Doors will come spot glued together so your body finisher can separate and install your window mechanisms much easier, then he can bond inner and outer together for final fit and finish.
All four corner body plates are installed, as well as rocker panel struts ('56 - '62), under dash w/s support system.
1958 thru 1960
Spare tire wheel well to fit the 5 1/2" original tires $250.00
Trunk - top deck hinges
All 4 corner brackets and braces
Under dash w/s support system
Bolt brackets in hood, trunk and top deck
Typical BODY ASSEMBLY
Bare floor pan - starting point.
Rear top surround being positioned correctly.
Under dash w/s support assembly being installed together with lower dash and door posts.
Rocker panel being fitted.
Inner door panel fitted to body along with pre-assembled front end assembly.
Door fitted in body.
Trunk lid fitted utilizing our own hinge design.
Hood fit front view.
'58-62 - Cableless w/s wiper assembly by Rain Gear
Standard 2 Speed Switch $429.95
Intermittent/Delay Switch $474.95
NOTE: PRICES SUBJECT TO CHANGE WITHOUT NOTICE.
Distributors for Art Morrison "G" force chassis, Tray Walden's Street Shop chassis.